Blade mQX Manuál s instrukcemi stáhnout pdf (Strana 4)

First Flight Preparation

• Removeandinspectcontents

• Beginchargingtheightbattery

• InstalltheightbatteryintheQuad-Copter

(onceithasbeenfullycharged)

• Programyourcomputertransmitter(BNFOnly)

• Bindyourtransmitter(BNFOnly)

• Familiarizeyourselfwiththecontrols

• Findasuitableareaforying

Flying Checklist

❏ Always turn the transmitter on ﬁrst

❏ Plugtheightbatteryintotheleadfromthe

4-in-1controlunit

❏ Allowthe4-in-1controlunittoinitializeand

armproperly

❏ Flythemodel

❏ Landthemodel

❏ Unplugtheightbatteryfromthe4-in-1

controlunit

❏ Always turn the transmitter off last

Battery Warnings and Guidelines

Low Voltage Cuto (LVC)

WhenaLi-Pobatteryisdischargedbelow3V,thebatterymaybecomedamagedandmaynolongeracceptacharge.

ThemQX4-in-1controlunitprotectstheightbatteryfromover-dischargeusingLowVoltageCutoff(LVC).Beforethe

batterychargedecreasestoomuch,LVCbecomesactive.PowertothemotorsdecreaseandtheLEDonthe4-in-1

controlunitblinks,showingsomebatterypowerisreservedforightcontrolandsafelanding.

Whenthemotorpowerdecreases,pleaselandtheaircraftimmediatelyandrechargetheightbattery.

DisconnectandremovetheLi-Pobatteryfromtheaircraftafterusetopreventtrickledischarge.Duringstorage,make

surethebatterychargedoesnotfallbelow3V.

NOTICE:RepeatedyingtoLVCwilldamagethebattery.

ThechargerincludedwiththemQXhasbeendesignedtosafelychargetheincludedLi-Pobattery.

CAUTION:Allinstructionsandwarningsmustbefollowedexactly.MishandlingofLi-Pobatteriescanresultin

are,personalinjury,and/orpropertydamage.

• Byhandling,chargingorusingtheincludedLi-Pobattery,youassumeallrisksassociatedwithlithiumbatteries.

• Ifatanytimethebatterybeginstoballoonorswell,discontinueuseimmediately.Ifchargingordischarging,

discontinueanddisconnect.Continuingtouse,chargeordischargeabatterythatisballooningorswellingcan

resultinre.

• Alwaysstorethebatteryatroomtemperatureinadryareaforbestresults.

• Alwaystransportortemporarilystorethebatteryinatemperaturerangeof40–120ºF.Donotstorethebattery

ormodelinacarordirectsunlight.Ifstoredinahotcar,thebatterycanbedamagedorevencatchre.

• NEVERUSEANNi-CdORNi-MHCHARGER.Failuretochargethebatterywithacompatiblechargermaycausea

reresultinginpersonalinjuryand/orpropertydamage.

• Neverexceedtherecommendedchargerate.

• NeverdischargeLi-Pocellstobelow3Vunderload.

• Nevercoverwarninglabelswithhookandloopstrips.

• Onlychargeorrechargebatteriesthatarecooltothetouch.

RTF

Installing the Transmitter Batteries

InstallAAbatteriesintotransmitter,notingpolarity.Replace

thetransmitterbatterieswhenthepowerLEDashesandthe

transmitterbeeps.

1 2 3 4 5 6 7 8 9 ... 67 68

Komentáře k této Příručce

Žádné komentáře

Blade mQX Manuál s instrukcemi Strana 4

Komentáře k této Příručce